output is the moving sum of the last N samples, scaled by the scale factor
Constructor Specific Documentation:
Create a moving average block.
Parameters: |
|
---|
Get the scale factor being used.
Set the length.
Set both the length and the scale factor together.
Set the scale factor.
output is the moving sum of the last N samples, scaled by the scale factor
Constructor Specific Documentation:
Create a moving average block.
Parameters: |
|
---|
Get the scale factor being used.
Set the length.
Set both the length and the scale factor together.
Set the scale factor.
output is the moving sum of the last N samples, scaled by the scale factor
Constructor Specific Documentation:
Create a moving average block.
Parameters: |
|
---|
Get the scale factor being used.
Set the length.
Set both the length and the scale factor together.
Set the scale factor.
output is the moving sum of the last N samples, scaled by the scale factor
Constructor Specific Documentation:
Create a moving average block.
Parameters: |
|
---|
Get the scale factor being used.
Set the length.
Set both the length and the scale factor together.
Set the scale factor.
output = input or zero if muted.
Constructor Specific Documentation:
Parameters: | mute – |
---|
output = input or zero if muted.
Constructor Specific Documentation:
Parameters: | mute – |
---|
output = input or zero if muted.
Constructor Specific Documentation:
Parameters: | mute – |
---|
output = input or zero if muted.
Constructor Specific Documentation:
Parameters: | mute – |
---|
sample and hold circuit
Samples the data stream (input stream 0) and holds the value if the control signal is 1 (intput stream 1).
Constructor Specific Documentation:
sample and hold circuit
Samples the data stream (input stream 0) and holds the value if the control signal is 1 (intput stream 1).
Constructor Specific Documentation:
sample and hold circuit
Samples the data stream (input stream 0) and holds the value if the control signal is 1 (intput stream 1).
Constructor Specific Documentation:
sample and hold circuit
Samples the data stream (input stream 0) and holds the value if the control signal is 1 (intput stream 1).
Constructor Specific Documentation:
Output a 1 or zero based on a threshold value.
Test the incoming signal against a threshold. If the signal excedes the value, it will output a 1 until the signal falls below the value.
Constructor Specific Documentation:
Parameters: |
|
---|